Avtech AVC796 User Manual download pdf (Page 12)

CONNECTIONS AND SETUP

-8-

3. CONNECTIONS AND SETUP

Note: The DVR is designed to automatically detect the video system of the connected cameras (NTSC or

PAL). To make sure the system detection is correct, please check if the cameras are connected to

the DVR and power-supplied before the DVR is powered on.

3.1 SATA HDD Installation

The SATA HDDs must be installed before the DVR is powered on.

3.1.1 For 16CH& 8CH Models

STEP1: Remove the screws on the top cover of DVR, and remove the top cover.

With the front panel facing you, there are two HDD brackets: one is on the left, and the other one is at the

middle.

STEP2: Install the compatible HDD to the bracket.

2.1. To install the HDD on the left:

a) With the PCB side facing up, connect the compatible HDD to the power connector and data bus

connector.

b) Put the compatible HDD in the left bracket, and fasten it with the supplied screws, two for each side.

2.2. To install the HDD at the middle:

a) Remove the bracket.

b) With the PCB side facing up, slide the HDD into the HDD bracket.

c) Fix the HDD with the supplied screws to the bracket, two for each side.

STEP3: Connect the compatible HDD to the power connector and data bus connector.

STEP4: Replace the bracket back to the DVR.

STEP5: Replace the top cover and fasten the screws you loosened in STEP1.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 65 66

No comments

Avtech AVC796 User Manual Page 12