Avtech IVS User Manual download pdf (Page 8)

2-2 To install on the second bracket

Connect the power connector and data bus connector

to the HDD.

Align the screw holes of the bracket with the HDD’s

screw holes. Make sure the PCB side of the HDD is

facing up. Then, fasten the HDD to the bracket.

Step3: Close the upper cover of the DVR, and fasten all the screws you loosened in Step1.

 For 4CH Model

Step1: Remove the screws on the top cover of DVR, and remove the top cover.

Step2: Remove the HDD bracket. Then, with the PCB side facing up, connect the compatible HDD to the power

connector and data bus connector.

Step3: Put the compatible HDD in the bracket, and fasten it with the supplied screws, two for each side.

Step4: Replace the bracket back to the DVR.

Step5: Replace the top cover and fasten the screws you loosened in Step1.

2.3 Installing DCCS Camera

Install the camera on the wall or ceiling based on your installation environment and camera type. For installation

details, please refer to the user manual of your camera.

Note: The distance between the camera and DVR needs to be within 200 meters for DCCS control to take

effects. For details, please refer to “2.1 Prerequisites” at page 2.

2.4 Connecting DCCS Camera

The cameras must be connected and power-supplied before the DVR is powered on. Connect the camera with

the indicated power supply. Then, connect the camera video output to the DVR video input port with a coaxial

cable or RCA cable with BNC connectors.

Note: To ensure the DCCS camera works properly, connect it to the video channel which supports DCCS

function:

For 16CH DVR: CH1 ~ CH4;

For 8CH DVR: CH1 ~ CH2;

For 4CH DVR: CH1.

1) Video cable connection

Connect the camera video output to the DVR video input port with a coaxial cable or RCA cable with BNC

connector.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

No comments

Avtech IVS User Manual Page 8